- Register an account in our system and log in (it will be suitable not only for the pool, but also for other projects that will be released in the near future)
- Go to the web interface of your equipment and enter the settings below, MORE FOR BEGINNERS: launch your ASIC, connect it to the Internet and while in the same network (for example, connect to the same wifi to which you connected it with a wire) use any network scanner, for example Advanced Ip Scanner and find the IP of your device, then enter the IP in the address bar of your browser (if it does not open, try another IP from the scanner), after you have entered the IP, the web interface will open, by default on most equipment the password and user are the same and will be "root" without quotes, if it does not work, then ask the password from the person from whom you bought the equipment, in the settings section of the web interface find the pool settings, go here on the pool to your account and enter the settings indicated below (those that you can click on)
If your equipment is located in Russia, you can mine to this address even under whitelist-based blocking. This address should be reachable via the MegaFon provider, but you can try it with others as well.
If you are logged into your account, then here will be shown your USER_STRATUM_ID
If you need - you can also specify the difficulty you need for your equipment, just specify it in the password: d=1024000 however, please note that if you set the difficulty too low for your specific hardware, the setting will not be applied. The static difficulty setting is only needed for Nicehash and other high-speed per-connection leases. For any standard hardware or leases with MRR, we strongly recommend leaving the password blank or entering a single English character if the hardware does not accept a blank password. There is also another parameter specifically for nicehash, written after the previous one, separated by a comma, which sets the minimum difficulty for the order: md=1024000